Construction lessons
Customer pain points and project conclusions
Needle holes, small incisions, cross-sections, fractures and large-area contamination cannot be treated in the same way. Patches should cover the defective outer edges and use round corners; complex nodes should usually be replaced with squeezed pads, long-distance continuous defects or areas of severe ageing contamination. All repairs must be numbered, mapped and individually detected.
Construction lessons
Procurement and Acceptance Checklists
| The checkpoint | Control requirements | Delivery of evidence |
|---|---|---|
| The classification of defects | The size, direction, location, pollution | Defects in photos and coordinates |
| Patch materials | The same material and thickness, rounded corners, cover enough | Batch of materials |
| Re-examination | Vacuum box/spark/point by point | Repair of the test table |
Construction lessons
Steps to landing
- Clean and polishedThe water, soil and oxidation layer are removed and the width of the abrasion is controlled.
- Selecting the ProcessThe flat surface is small with patches and the knots are compressed.
- Re-examination of the coolingAfter complete cooling, the test is performed and the graph is entered.
Construction lessons
Common risks and addressing them
- The water is soaked in the wetThe water vapor forms air vents and noise.
- The tip of the patchThe stress concentration can easily tear itself apart from the tip again.